Pppoe - Zhone zNID-GPON-2402 Configuration Manual

Configuration pages

PPPoE

The Point-to-Point Protocol over Ethernet (PPPoE) encapsulates PPP frames
inside Ethernet frames to create a PPPoE tunnel between hosts connected to
the ZNID and other devices out in the cloud. While Ethernet is packet-based
(so no direct connection is opened), PPP is a direct connection where one
device directly connects to another using the protocol. PPPoE is a virtual
connection (usually called tunnel) between two devices.
On the Configuration | Interfaces | PPPoE page you can add a PPPoE on a
port by VLAN, either as PPPoE Routed or PPPoE Bridged.
To create PPPoE tunnels see Creating PPPoE tunnels, page 179
Figure 75: The PPPoE Interface Setup page
To edit a routed interface, enter a check in the routed interface in the select
row at the top of the table, then click Edit Selected Interface.
103
zNID 24xx Series Configuration Guide