Zhone zNID-GPON-2402 Configuration Manual page 186

Configuration
186
zNID 24xx Series Configuration Guide
Note: Make sure that a VLAN is created with a matching VLAN
ID and the LAN ports are configured as untagged members of
that VLAN.
The default PVID is only used to determine how ingress untagged
traffic will be tagged. The VLAN table defines the egress action.
e
From the Uplink eth0 should be selected
Selecting the Fiber WAN interface adds this VLAN to the uplink.
f
Click Save/Apply
3 Adjust WAN settings
For PPPoE connections the default settings are automatically configured
for the WAN interface.
a From the Interfaces | PPPoE page enter a check in the select column
for eth0.v404, then click Edit Selected Interface
b In the Configuration - Routed Interface --> Edit Selected
Interface page from the IP Configuration section Address Mode
dropdown PPPoE will be set.
Figure 147: For PPPoE you just need to add the username, password and
authentication type
For PPPoE the device addressing mode is PPPoE by default.
c
In the NAT/NAPT dropdown below Client Addressing, NAT will be
selected
For PPPoE NAT is selected by default.