Zhone zNID-GPON-2402 Configuration Manual page 182

Configuration
182
zNID 24xx Series Configuration Guide
b In the Configuration - Routed Interface --> Edit Selected
Interface page from the IP Configuration section Address Mode
dropdown PPPoE will be set.
Figure 142: For PPPoE you just need to add the username, password and
authentication type
For PPPoE the device addressing mode is PPPoE by default.
c In the NAT/NAPT dropdown below Client Addressing Enable will
be selected
For PPPoE NAT/NAPT is enabled by default.
d In the DNS Relay Source dropdown PPPoE is selected.
For PPPoE the DNS relay source is set to PPPoE by default.
e Set the PPP username, password and authentication method
In the Username, Password, Service Name and Retry Interval text
boxes enter the information supplied by your ISP.
In the Authentication dropdown select Auto, or the option requested
by your ISP.
4
Adjust LAN settings
For PPPoE connections the LAN side you define the IP address of the
interface and the subnet using DHCP (by default).
a
From the Interfaces | Routed page enter a check in the select column
for eth3.v403, then click Edit Selected Interface
b In the IP Address text box below IP Configuration enter an IP
address (192.168.100.1) and in the Subnet Mask define the mask for
the subnet (255.255.255.0)