Zhone zNID-GPON-2402 Configuration Manual page 187

d Set the PPP username, password and authentication method
In the Username, Password, Service Name and Retry Interval text
boxes enter the information supplied by your ISP.
In the Authentication dropdown select Auto, or the option requested
by your ISP.
4
Adjust LAN settings
For PPPoE connections the LAN side you define the IP address of the
interface and the subnet using DHCP (by default).
a
From the Interfaces | PPPoE page enter a check in the select column
for eth4.v404, then click Edit Selected Interface
b In the IP Address text box below IP Configuration enter an IP
address (192.168.102.1) and in the Subnet Mask define the mask for
the subnet (255.255.255.0)
c
From the DHCP Server dropdown below Client Addressing select
Enable.
Figure 148: Defining the subnet for the PPPoE bridged VLAN
d In the Subnet Range Start Address text box enter a start address for
the subnet (192.168.102.10)
e
In the Stop Address text box enter an ending address for the subnet
range (192.168.102.100)
f
In the Lease Duration (sec) text box enter 86400.
86400 is 24 hours (in seconds, 60 x 60 x 24)
5
Configure Wireless (Wireless connections only)
Set port membership, authentication and encryption features as well as
other wireless options. See Creating wireless connections, page
zNID 24xx Series Configuration Guide
Deployment scenarios
188.
187