Zhone zNID-GPON-2402 Configuration Manual page 59

Table 10: Device Info page display
UI Label
System Date and Time
System UpTime
Model Number
Serial Number
Registration ID
FSAN
Bootloader Version
Firmware Version
Alternate Firmware
Version
Interface Names
System Alarms
Figure 34: Bootloader and firmware version
Description
System Date and Time is drawn from SNTP (Simple
Network Time Protocol) servers. Multiple servers are
given in case access to the server is lost. Selecting the
SNTP server and other settings can be configure in
Internet time, page 37.
System UpTime displays the duration of time since the
device was last booted. This information can be useful
when troubleshooting.
The model number of the device. This information is
useful when describing the device for troubleshooting.
This information is read only and cannot be changed.
Uniquely identifies the device within the context of
Model Number & Serial Number.
The identification number entered when the ONU is to
be registered using the Reg ID programming procedure
(described in the Release Notes).
A number that uniquely identifies the device on the
PON to the OLT
Level of firmware used to load the ONU. This
information can be useful when troubleshooting.
Level of firmware actively running the device. This
information can be useful when troubleshooting.
Level of firmware residing in the ONU but not
currently running.
Each interface has its own unique MAC address. The
interface name is shown (Fiber WAN— the network
facing interface,GE1, GE2 and so on are subscriber
facing interfaces).
This display shows if any alarms are currently active on
the system if any. This example shows that no alarms
are now present.
zNID 24xx Series Configuration Guide
Device info
59