Configuration
152
zNID 24xx Series Configuration Guide
Table 56: In the VLAN editing screen, only the port membership for the VLAN
may be defined
UI Label
Cross VLAN Routing
Mode
Description
When Enable is selected routing between VLANs is
allowed.
•
Enable
Route table lookups ignore the VLAN ID of the
ingress and egress ports. If there is a match, the
packet is routed out the interface specified in the
Route table, regardless of which VLAN it is a
member of. (Cross VLAN Routing disabled is the
default behavior.)
•
Disable
Packets will be forwarded to the configured
Default Route for the VLAN that they arrived on,
unless there is a Route Table match within that
same VLAN. Routing of packets across VLANs is
prevented, providing traffic isolation.