Reviewing Iperf Test Results; Results Always Included - Netscout AirCheck G2 User Manual

Reviewing iPerf Test Results

The iPerf screen shows the following measurements, some
with Pass (green), Fail (red), or Warning (yellow) results:
NOTE: To adjust the Pass/Fail thresholds, TCP/UDP, and
other settings for the iPerf Test, go to Settings > iPerf
Settings on your AirCheck G2.
101.
Touch Start to run another iPerf test to the same iPerf Server.

Results Always Included

BSSID: The network's BSSID.
SSID: The network's SSID.
iPerf Server Address: The iPerf endpoint's IP address.
PHY Data Rate: The Wi-Fi physical data rate in Mbps.
Signal Level: The network's signal level in dBm.
Noise Level: The network's noise level in dBm.
SNR: The network's signal-to-noise ratio in dB.
Retry Rate: The percentage of transmitted frames that are
Wi-Fi retry frames.
See "iPerf Settings," page
Figure 59. iPerf Test TCP Results
83
Conducting iPerf Performance Testing