The Ap Range Test Screen - Netscout AirCheck G2 User Manual

The AP Range Test Screen

Figure 55. AP Range Test Screen
The Range Test screen shows the following information:
AP Name: The name of the AP to which AirCheck G2 is
currently connected.
Target: The selected test target.
Ping Stats: The percentage of ping packets lost. Select the
down arrows to expand for the following detailed
information:
IP Address: The IP address of the target to which
AirCheck G2 is sending ping packets.
Pings Sent: The number of ping packets sent.
Pings Returned: The number of ping packets returned.
Pings Lost: The number of ping packets lost.
Avg Ping Rsp Time: The average ping response time.
Min Ping Rsp Time: The minimum ping response time.
Max Ping Rsp Time: The maximum ping response time.
NOTE: When a range test is stopped, there may still be a
few ping packets in transit that have not yet been
received and have not timed out as to count as lost
pings. Therefore, the reported number of pings received
and the number of pings lost may not add up to the total
number of pings sent. The difference is just the number
of pings in transit when the test was stopped.
78
Performing an Access Point Range Test