How To: Edit A Network; How To: Delete A Network; Access Points; How To: Add An Ap And Configure Ap Settings - Netscout AirCheck G2 User Manual

3 If the network is behind a Captive Portal, switch the
toggle to On to enable the Captive Portal setting.
4 Touch the down arrow
and select and configure an authentication type from the
drop-down menu.
5 Enter all necessary Authentication credentials for the
security type used on the network, such as Encryption
type, Keys, EAP Type, Username, and/or Password.
6 If you want to use DHCP as the IP address mode, leave
DHCP enabled. To use a Static address, you must specify
the following:
 Static IP Address
 Subnet Mask
 Default Gateway
 Primary DNS
 Secondary DNS
7 Select Apply to confirm your network configuration.

How to: Edit a network

1 Select the (Edit) icon.
2 Make the desired changes.
3 Select Apply.
in the Authentication field,

How to: Delete a network

1 Select the (Delete) icon.
2 Select Yes in the pop-up confirmation message window.

Access Points

These settings allow you to add, edit, and delete APs and
their saved configuration.

How to: Add an AP and configure AP settings

1 Select Add AP to open the Configure AP screen.
2 Select BSSID to bring up a text entry screen, where you
can use the keyboard to specify the AP's BSSID, and
select DONE.
3 Select Alias Name to bring up a text entry screen, where
you can use the keyboard to specify the AP's name, and
select DONE.
4 Touch the down arrow
field, and select an Authorization for the AP.
5 Select Apply to save your configuration.
6 Repeat Steps 1 through 4 to add more APs if needed.

How to: Edit an AP

1 Select (Edit).
92
All AirCheck G2 Settings
in the Authorization Class