The Access Points List Screen - Netscout AirCheck G2 User Manual

 For multiple channels, it displays all channel numbers
if space permits; otherwise, it truncates to what fits,
followed by "...".
Last Seen: The time since the last packet was detected from
the selected network.
Connect: Touch this button to connect to the Wi-Fi network
and run a Connection test.
Network or Connect to AP Test," page 58.
Save: Touch this button to save a session file containing
the discovery or test results that have been collected since
the AirCheck G2 last refreshed.
Packet Captures," page 85.
See "Running a Connect to
See "Saving Sessions and

The Access Points List Screen

Touch Access Points on the Home Screen to open the list of
discovered APs.
NOTE: If Group Virtual APs is enabled in the Tester's
Settings, virtual APs are grouped by BSSID, and the
Access Points list shows individual physical APs.
If the AP grouping setting is Off, each virtual access point
is shown as a single access point.
The Tester displays an access point that supports both
bands as two separate access points, regardless of AP
grouping settings.
See "802.11 Settings," page 94.
14
Discovering Networks and Access Points