How To: Enter Credentials In The Settings Menu; How To: Enter Credentials In Aircheck G2 Manager - Netscout AirCheck G2 User Manual

4 If the network or AP has not yet been configured on the
current profile, the Configure screen opens; enter the
appropriate credentials on the configuration screen.
See "Networks," page 91
network settings.
5 Click the Apply button at the bottom of the screen.
The Tester will run a Connection test. Afterwards, the
credentials for the Network or AP are retained in the unsaved
Profile, which is denoted with an asterisk (*) (shown in
32).
NOTE: Notice that the Profile name at the top left of the
screen has an asterisk because the Profile has not been
saved with the new credentials. Once you enter security
credentials for an SSID (or multiple SSIDs), save them to a
Profile to avoid losing these settings if another Profile is
loaded or if the Tester firmware is updated.

How to: Enter credentials in the Settings menu

1 From the Home Screen, touch the
2 Select Networks.
3 On the Networks settings screen, touch Add Network.
See Figure 32.
4 Enter the necessary SSID.
for more on configuring
Figure
Settings button.
Figure 32. Configured Networks in Settings
5 Configure Network settings as needed.
See "Networks," page 91
network settings.
6 Touch Apply to add the credentials to the Profile. You
should see your new network's name listed in
Settings > Networks, as shown in

How to: Enter credentials in AirCheck G2 Manager

NOTE: See the AirCheck G2 Manager Help
additional instructions.
1 Connect the Tester to a PC with AirCheck G2 Manager
installed.
2 Open the AirCheck G2 Manager application.
50
Customizing the Tester for your Network
for more on configuring
Figure 32.
for