Test Targets - Netscout AirCheck G2 User Manual

the Select iPerf Server screen. If you have multiple Test
Accessories, select the most common battery type. This
setting is not relevant for Test Accessories running on PoE.
Thresholds — This button is a shortcut to the Settings >
Thresholds screen section for iPerf Thresholds. Touch to
open the Thresholds settings, where you can adjust the
Target Speed, Loss Percentage, and Jitter thresholds for iPerf
test results. NOTE: Loss and Jitter only apply when iPerf
testing with the UDP protocol.
Touch Apply to save your changes to the settings.

Test Targets

Test targets are part of Connect to Network, Connect to AP,
and AutoTest Network Tests. The Test Targets screen
provides tools for you to select, add, change, and delete test
targets.
Figure 66. Test Targets Screen
See also, "Defining Ping and TCP Port Open Test Targets" on
page 56.
102
All AirCheck G2 Settings