Netscout AirCheck G2 User Manual page 94

When you open the Select iPerf Server screen, the AirCheck
G2 begins automatically scanning for NETSCOUT Test
Accessories that are available for iPerf testing. Search for and
select the appropriate iPerf test endpoint using the following
methods:
The currently selected iPerf Server IP address displays in

the top field on this screen. Touch any of the discovered
Test Accessories in the Available iPerf Remotes list
during or after scanning to populate the iPerf Server field
with the selected IP address.
Figure 58. Touch to Select an iPerf Server
If you know the IP address of your iPerf server software

or Test Accessory, you can manually enter it by touching
the iPerf Server IP Address field. Touch DONE to save the
new address.
NOTE: To use iPerf server software installed on a PC, you
must type in the IP address manually by touching the
iPerf Server field at the top of this screen.
If you have recently run an iPerf test on the AirCheck G2,

the iPerf Server field autopopulates with the last known
iPerf server's IP address. Touch the drop-down arrow
to select another, recently used iPerf server address.
The AirCheck G2 shows the last five addresses used in
the drop-down list.
The AirCheck G2 scans its current local subnet and the

subnet of the last Ethernet test
Access Point Backhaul" on page
currently loaded profile for available iPerf servers.
"How to: Discover a NETSCOUT Test Accessory using
the Ethernet Test," page 82.
You can also manually enter an IP Subnet to be scanned

by touching the Additional Subnet field. Touch Rescan
after entering a subnet to scan the subnet.
If you have a Link-Live Cloud Service account that is

currently configured to receive your test results, AirCheck
G2 queries Link-Live for any claimed Test Accessories
and displays them in the list of Available iPerf Remotes.
81
Conducting iPerf Performance Testing
("Testing Ethernet for
44) run while using the
See