6.3.1
Performing Wiremap test
1.
Disconnect the cable path to be tested from all network components.
2. Connect the LanXPLORER to one end of the cable path.
3. Connect an Active Remote to the other end of the cable path.
4. Select the menu point "Tests" on the standby screen.
5. Select the menu point "Wiremap".
6. Select Run to start the Wiremap test.
6.3.2
Display results
DISPLAYS ON THE ACTIVE REMOTE
A flashing LED on the Active Remote indicates the test status:
LED display
Red, slowly
Fast red:
Green, fast
Orange
WIREMAP
Description
Item
1
Type of cable set
2
Display Preference of comparison standard
3
Wiremap results
4
LanXPLORER
5
Length of pairs
6
Lines
7
Total length
8
Active Remote (indicated by LED display).
LanXPLORER Pro
User Manual
Description
The end is near has been detected – Test not
performed.
Fault
The end is near has been detected - Cable path is okay
Incorrect voltage
2
1
6
8
7
Figure 57: Wiremap (pass)
150835 Iss 5
Page 40
3
5
4