IDEAL Networks LanXPLORER Pro Manual page 60

Ports - WiFi
•
SSID: Text entry by full virtual keyboard, Entry from WiFi scan
• Encryption: None, WEP, WPA-PSK, WPA2-PSK
• Key/Key Type: Text entry by full virtual keyboard / ASCII, HEX
• Sensitivity: Designed for convenient network testing via local access points.
• Internal or external antenna not intended for comparative measurements of
distant access points.
• Included high sensitivity external USB antenna for enhanced detection of lower
signal strength access points
• Frequency: 2.4GHz
• Mode: 802.11b/g/n
•
Scan: Signal strength indication, SSID, BSSID, Channel, Mode (802.11b/g/n),
Encryption (None / WEP / WPA / WPA2)
• Network Tests: Netmap, Ping, Net Verify, Trace Route, Auto, Conflicts
In-Line Tests
• PC Diagnostics Results:



• VOIP Test Protocols: Session Initiation Protocol (SIP)
• VOIP Test Setup: VoIP Port 1:1 to 65535. VoIP Port 2: 1 to 65535. Max Jitter
Test Threshold (ms): 1 to 999999, Max Delay Test Threshold (ms): 1 to 999999.
Max Lost Packets Test Threshold (%):1 to 100
• VOIP Test Results:



Cable Tests
• Wiremap Setup




• Wiremap Termination Type: None – Open, Active Remote - #1 - #12
• Wiremap Tests (No Termination)


•
Wiremap Tests (Active Remote Termination)


LanXPLORER Pro
User Manual
Protocols: Protocol, Frames. Traffic: Host IPv4 address, Peak Mb/s.
IP data: Info, IPv4 address, Gateway, Subnet mask, Primary DNS,
Secondary DNS, DHCP Server.
Link: Errors, Info, 802.1x status
Call Log: Last 20 calls, Call start time, Destination number, Call length
(mm:ss) port number (destination & source).
Jitter: Last successfully connected call (ms to 3 decimal places),
according to RFC3550 (Max, Min, Ave, Cur)
Delay: Last successfully connected call (ms) (Max, Min, Ave, Cur)
Cable Type: Cat3 UTP, Cat3 STP, Cat5 UTP, Cat5 STP, Cat5e UTP, Cat5e
STP, Cat6 UTP, Cat6 STP, Cat7, USOC, ETH S12-
36, ETH S12-78, ETH U1236, ETH U1278, IND. M12, COAX RJ59.
Colour Scheme: None, 568A, 568B, USOC, TERA.
Cross Over Allowed: Yes, No.
NVP: Fixed 72%, Custom 59% - 89%
Faults: Open circuit by pin, Short circuit by pin.
Length of pair: Metres / Feet (Set in System Setup), Range 100m /
390ft
I/D–Remote #
Indications on Remote: Voltage Warning (>±10volts on any pins),
Pass/Fail.
150835 Iss 5
Page 59