IDEAL Networks LanXPLORER Pro Manual page 61



• Tone Generator Setup


Endpoint Tests
• VLAN

• IP version: IPv4, IPv6
•
IPv4 Addressing: DHCP, Static.
• IPv6 Addressing : Static, Stateful, Stateless
• Netmask. Gateway. DNS1: Numerical address only. DNS2: Numerical address
only
•
Netmap Setup



•
Netmap Results


• Ping Setup




• Ping Results




• PoE Setup



• PoE Results





• Net Verify Setup

• Net Verify Results




• Trace Route Setup
LanXPLORER Pro
User Manual
Faults: Open circuit by pin, Short circuit by pin, Crossed pairs, Split
pairs, Bridged shorts, Remote shorts.
Length of pair: Metres/Feet (Set in System Setup), Range 100m/ 390ft
Tones: 3. Wire I/D: Tone applied to one of 8 pins relative to the other 7,
Tone applied across one of 4 pairs
Tone Generator Test Audible tone detected using compatible tone
probe
VLAN: Enabled, Disabled. ID: 0 to 4094. Priority: 0 to 7
Network: Local, Custom.
IPv4 Address: Scan Range: Normal (000.255), Wide (015.255)
IPv6 Scan: Enable/ disable
Hosts count: All Hosts, Server Hosts (differentiation based on services /
ports), Printer Hosts (differentiation based on services / ports).
Host details: Host Name, IPv4/6 Address, MAC Address, Services
Detected
Target: IP address, URL.
Count: 1 to 999999.
Pause: 0 to 5000 ms.
Length: 8 to 3000 bytes
Info: READY, IN PROGRESS, PASSED, NO RESPONSE, UNKNOWN
HOST.
Tx Count: 0 to 999999.
Rx Count: 0 to 999999.
Delay(ms): Minimum, Average, Maximum
Test Type: PoE, PoE Plus.
Min PoE Power Test Threshold: 1 to 15 watts.
Min PoE + Power Test Threshold: 1 to 28 watts
Status: READY, FAILED NO POE DETECTED, PASSED.
Pair: 12/36, 45/78.
Voltage: 0 to 60 volts.
Current: 0 to 600 mA.
Power: 0 to 36 watts
Comparison Map: Stored map from previous Netmap test
Hosts count : All Hosts Same / Different,
Server Hosts Same / Different,
Printer Hosts Same / Different.
Host details: Host Name, IPv4 Address, MAC Address, Services
detected
150835 Iss 5
Page 60