IDEAL Networks LanXPLORER Pro Manual page 59



•
Secondary RJ45 Activity LED: Flashing indicates Secondary link activity


• Optical Link LED: ON indicates Optical link UP


• Optical Activity LED: Flashing indicates Optical link activity


• Screen LCD







Ports - RJ45
• Mode: Full Duplex, Half Duplex
• Min. RX size: 19-99
• MAC: Factory set
• Cable Mode Tests: Wiremap, Tone Generator, Auto (Wiremap)
•
Endpoint Mode Tests: Netmap, Ping (IPv4 &IPv6), PoE, Net Verify, Trace Route
(IPv4 &IPv6), Loopback, Top Ten, Hub Blink, Auto (PoE Load, Ping, Trace
Route, Network Verify), Conflicts
•
In-Line (Monitor) Mode Tests: PC Diagnostics, VoIP, Top Ten, Service Detection
(PoE, ISDN s (with audible warning), PBX (with audible warning), Unknown
(with audible warning)
• VLAN



•
Auto Detect Mode Cable, Endpoint, In-Line (Monitor)
• Auto Negotiation: Disabled or Enabled
• Speed: 10Mbps, 100Mbps & 1Gbps
• Link Pulse Polarity: Normal, Inverted
• Link Pulse Height: Normal, Low
Ports - Optical
• The following SFP types are supported. Use of other types of SFP is possible
but correct operation is not guaranteed



•
Optical Tests: Tx Power dBm (using a specified SFP), Rx Power dBm (using a
specified SFP)
Network Tests: Netmap, Ping, Net Verify, Trace Route, Loopback, Top Ten,
Hub Blink, Auto (Ping, Trace Route, Network Verify), Conflicts
LanXPLORER Pro
User Manual
Green
Adjacent to Secondary RJ45 socket
Green
Adjacent to Secondary RJ45 socket
Green
Adjacent to SFP socket
Green
Adjacent to SFP socket
Type - QVGA Colour
Resistive touch screen
Pixels - 320 x 240
Use - Display of setup
functions and results
Size - 3.5 inch diagonal
Location - Front
Enabled, Disabled
VLAN ID 0 to 4094
VLAN Priority 0-7
SFP Type SX Manufacturer Part # Avago AFBR-5705Z / APAC LM28-
C3S-TI-N-DD 1Gbps Multimode 850nm LC Duplex
SFP Type LX Manufacturer Part # Avago AFCT-5705Z 1Gbps Single
mode 1310nm LC Duplex
SFP Type ZX Manufacturer Part # APAC LS48-C3U-TC-N-DD 1Gbps
Single mode 1550nm LC Duplex
150835 Iss 5
Page 58