Loop; 6.12.1 Performing Test; Pc Diagnosis - IDEAL Networks LanXPLORER Pro Manual

6.12
This test allows measurement of the network transfer rate. In this test the LanXPLORER
serves as a reply box for a measuring instrument with active layer (up to stage 4) (e.g. Trend
Unipro or Trend Multipro).
The LanXPLORER can be set to one of the following types of loops, preset in the instrument:
• Wireline
• Mac
• IP
• UDP

6.12.1 Performing test

1. Select Setup.
2. Set the type of loop specified by the measuring instrument with active layer.
3. Save the entry made with Apply. You can exit the menu without saving the
changes with Escape.
4. Select Run to start the test.
6.13
With this test the LanXPLORER can provide information on the MAC and IP level of the
connected PC. Moreover information is output on data transfer (traffic).
1. Select the menu point "PC Diag".
2. The traffic is automatically analyzed.
LanXPLORER Pro
User Manual

Loop

PC Diagnosis

Figure 69: PC Diagnosis
150835 Iss 5
Page 48