IDEAL Networks LanXPLORER Pro Manual page 21

Setting the wiremap
This menu allows you to set the type of wiring.
1. Select the menu point "Wiremap".
Option Description
Cable Type Selection of type of cable.
Display Pref Selection of wiring schematic.
Xover Allowed Permit cross-over cables.
Use Custom Use own NVP value. (Allows precise length
NVP measurement of the pair.)
Entry of cable-specific NVP value (Nominal
Custom NVP Velocity of Propagation) in percent, e.g. 79
for 79%.
2. Select the desired option.
3. Select the desired test parameters or enter the desired information with the
alphanumeric keys.
4. Save the entry made with Apply. You can exit the menu without saving the
changes with Escape.
Setting the tone generator
This menu allows you to set the melody on the tone generator and the pin or pair to be
found.
1. Select the menu point "ToneGen".
2. Select the option Tone to set the melody.
3. Set the desired option.
4. Select the option Wire Id to set the pin or pair
to be found.
5. Set the desired option.
6. Save the entry made with Apply. You can exit
the menu without saving the changes with
Escape
LanXPLORER Pro
User Manual
Figure 24: Wiremap
Figure 25: Tone generator
150835 Iss 5
Page 20