Fiber-Optic Cable - IDEAL Networks LanXPLORER Pro Manual

Description
Item
1 Network connection status
Connection status of connected Ethernet
2
device.
5.5
This function allows all Ethernet-compatible devices to be tested in the end point mode.
NOTE:
This test function can be used only at an Ethernet transfer
rate of 1000 Mbit/s.
1. Plug in an SFP of the desired wavelength
2. Select the menu "Ports" "Optical".
3. Connect a fiber-optic cable to the Ethernet-
compatible device to be tested.
4. Connect the free end of the cable path to the
SFP plugged in the LanXPLORER.
5. Select Detect to start recognition of the
Ethernet-compatible device.
Item Description
Transfer rate of connected device and Rx
1
optical power.
2 IP address of connected device.
LanXPLORER Pro
User Manual

Fiber-optic cable

1
Figure 50: In Line Test
Figure 51: Typical test setup
for testing with fiber-optic
cable
1
2
Figure 52: Fiber-optic cable
150835 Iss 5
Page 36
2