Blink; 6.10.1 Performing Test; Power Over Ethernet (Poe); 6.11.2 Display Results - IDEAL Networks LanXPLORER Pro Manual

6.10
This test allows display of the Ethernet port to which the test cable is connected.

6.10.1 Performing test

1. Select the menu point "Blink".
2. Select Run to start the test.
The tester activates / deactivates the Ethernet link and cycles through the advertised rates.
On the Ethernet device the corresponding connection point then blinks intermittently and (if
supported) changes colour depending on the connected rate..
3. Select Stop to terminate the test.
NOTE:
Speed and colour of the blinking LED changes periodically and is dependent on the switch type.
6.11
6.11.1 Performing test
1. Select the menu point "PoE".
2. Select Setup to define the test parameters.
3. Save the entry made with Apply. You can exit the menu without saving the
changes with Escape.
4. Select Run to start the test.
The LanXPLORER then performs the following steps:
•
Measurement of incoming voltage;
• Measurement of incoming current;
• Calculation of resulting power;
• Comparison of test results with standard values.

6.11.2 Display results

Image Description
Passed –
Status
Failed –
Test Type Type of test on PoE or PoE+
Pair Pair used for PoE
Voltage Voltage
Current Current
Power Power
LanXPLORER Pro
User Manual

Blink

Power over Ethernet (PoE)

PoE recognized
PoE not recognized
Figure 68: PoE - test result
150835 Iss 5
Page 47