Chapter 3.
Settings
3.1
Principles
When the tester is switched on, the Startup screen is displayed. This allows selection of the
required test port.
If a test port is not available it is shown in grey.
If the box "Show this screen on start up" is unticked, the standby screen is displayed when
the tester is switched on instead of the Startup screen.
Figure 8: Startup screen
All instrument settings can be made with the Setup menu on the standby screen. From the
Setup menu it is possible to navigate to any of the submenus to make settings there.
1.
Select the menu point Setup.
2. Make the settings by selecting the applicable menu point.
3. Select More to display the next page.
Figure 9: Settings
LanXPLORER Pro
User Manual
Figure 7: Standby screen
Figure 10: Settings (page 2)
150835 Iss 5
Page 13