Exiting Programming Mode; Changing Lock Strike Code - Rosslare AYC-H6355 Installation And User Manual

Controller Functionality
8.9.2

Exiting Programming Mode

1. Press # twice.
You hear a long beep.
The Door LED turns off and the
Mode LED returns to Normal
mode.
Wrong entries reset the controller back to Normal mode.
While in Programming mode, if no key is pressed for one minute,
the unit exits Programming mode and returns to Normal mode.
8.9.3

Changing Lock Strike Code

The Lock Strike code is mainly used as a method to quickly test the
Lock Strike Relay during installation.
When the first user is added to the controller, the default Lock Strike
code is automatically deleted. Once the code is programmed again, it
is not deleted with the entry of additional user codes.
1. Enter Programming mode.
2. Press 1 to enter Menu 1.
The Mode LED turns red.
3. Enter the new code you wish to
set as Lock Strike Code 1.
You hear three beeps.
The system returns to Normal
mode.
40
Mode/Transmit
Mode/Transmit
Mode/Transmit
Mode/Transmit
AYC-x6355 Installation and User Manual
Door/Program
Green
Door/Program
Green
Door/Program
Red Green
Door/Program
Green