Replacing A Lost Programming Code - Rosslare AYC-H6355 Installation And User Manual

Controller Functionality
1. Enter Programming mode.
2. Select the desired PIN code length as follows:
00 – Returns to factory defaults and sets a 4-digit code.

05 – Returns to factory defaults and sets a 5-digit code.

06 – Returns to factory defaults and sets a 6-digit code.

08 – Returns to factory defaults and sets a 4- to 8-digit code

Both the Mode and Door LEDs
flash red.
3. Enter your 4- to 8-digit
Programming code
If the Programming code is valid, all memory is erased. You hear
three beeps and the controller returns to Normal mode.
If the Programming code is invalid, you hear a long beep and the
controller returns to Normal mode without erasing the memory
contents.
8.9.19

Replacing a Lost Programming Code

The AYC-Ex5 and AYC-T65 must be in Normal mode; otherwise,
this does not work. Make sure that the Mode LED is green
before proceeding.
To replace a lost Programming code:
1. Remove power from the Power Supply Unit.
2. Press the REX button on the Power Supply Unit.
3. Apply power to the unit with REX button pressed.
4. Release the REX button.
5. You now have 10 seconds to program a new Programming code
into the Access Control unit using the initial default code 1234,
before the controller reverts to the existing code.
60
Mode/Transmit
Mode/Transmit
AYC-x6355 Installation and User Manual
Door/Program
Green
Door/Program
Red Red