9
SHOCK ABSORBER, SWINGARM
9.18
Removing the heim joint
Info
The steps are identical on the upper and lower heim joints.
»
If the measured value is greater than the specified value:
–
Replace the piston rod.
–
Check the piston rod for damage and wear.
»
If there is damage or wear:
–
Replace the piston rod.
–
Check the piston rings for damage and wear.
»
If damage or a bronze-colored surface is visible:
–
Replace the piston rings.
201771-10
Condition
The shock absorber has been removed.
–
Clamp the shock absorber in a bench vise using soft jaws.
–
Remove both collar bushings
Pin (T120) (
201773-10
–
Remove seal rings
201774-10
–
Press the heim joint against a lock ring using the special tool.
Pressing tool (T1207S) (
–
Remove the second lock ring
201775-10
of the heim joint.
1
p. 210)
on both sides.
2
p. 211)
.
3
46