Service Schedule - KTM Freeride 250 R EU Repair Manual

28

SERVICE SCHEDULE

28.1 Service schedule
Check that the electrical equipment is functioning properly.
Check and charge the battery.
Check the front brake linings. (
Check the rear brake linings. (
Check the brake discs. (
Check the brake lines for damage and leakage.
Check the rear brake fluid level. (
Check the free travel of the foot brake lever. (
Check the frame and swingarm.
Check the swingarm bearing.
Check the heim joints at the top and bottom of the shock absorber.
Check the tire condition. (
Check the tire air pressure. (
Check the wheel bearing for play.
Check the wheel hubs.
Check the rim run-out.
Check the spoke tension. (
Check the chain, rear sprocket, engine sprocket and chain guide. (
Check the chain tension. (
Grease all moving parts (e.g., side stand, hand lever, chain, ...) and check for smooth operation.
Check the fluid level of the hydraulic clutch. (
Check the brake fluid level of the front brake. (
Check the free travel of the hand brake lever. (
Check the steering head bearing play. (
Check the inlet membrane.
Check the clutch.
Change the gear oil. ( p. 160)
Check all hoses (e.g. fuel, cooling, bleeder, drainage, etc.) and sleeves for cracking, leaks, and incorrect routing.
Check the antifreeze and coolant level. (
Check the cables for damage and routing without sharp bends.
Check that the cables are undamaged, routed without sharp bends and set correctly.
Clean the air filter and air filter box.
Check the screws and nuts for tightness.
Check the headlight setting. (
Check idle.
Check that the radiator fan is functioning properly.
Final check: Check the vehicle for roadworthiness and take a test ride.
Make the service entry in KTM DEALER.NET and in the service record.
●
Periodic interval
p. 84)
p. 89)
p. 70)
p. 91)
p. 91)
p. 69)
p. 69)
p. 70)
p. 75)
p. 155)
p. 86)
p. 86)
p. 30)
p. 157)
p. 97)
p. 76)
180
Every 50 operating hours
●
●
●
●
●
●
●
●
●
●
●
●
●
●
●
●
●
●
●
●
●
●
●
●
●
●
●
●
●
●
●
●
●
●
●
●
●
●