KTM Freeride 250 R EU Repair Manual page 27

6 FORK, TRIPLE CLAMP
–
Push on the lower sliding bushing
–
Mount the upper sliding bushing
Info
Without using a tool, pull the stack apart by hand slightly.
201440-10
–
Warm up the outer tube in area
Guideline
50 °C (122 °F)
–
Slide the outer tube onto the inner tube.
–
Hold the lower sliding bushing with the longer section of the special tool.
Mounting tool (T528S) (
–
Push the sliding bushing all the way into the outer tube.
201441-10
–
Position support ring.
–
Hold seal ring with the shorter section of the special tool.
Mounting tool (T528S) (
–
Push the seal ring and support ring all the way into the outer tube.
201442-10
–
Mount lock ring
Info
The lock ring must engage audibly.
201435-11
–
Install dust boot
201434-11
–
Mount adjusting tube
The adjusting tube extends 5 mm out from the cartridge and can be pressed
inward against the spring force.
The adjusting tube extends more than 7 mm out from the cartridge and cannot
be pressed inward against the spring force.
–
Screw on water excluder
Info
The water excluder must be screwed on tightly against the stop. Do not use
200725-11
tools.
.
5
.
6
of the lower sliding bushings.
A
p. 213)
p. 213)
.
2
.
1
of the rebound damping in the cartridge.
7
to the stop.
B
25