Handlebar, Controls; Handlebar Position; Adjusting The Handlebar Position; Adjusting The Basic Position Of The Clutch Lever - KTM Freeride 250 R EU Repair Manual

7

HANDLEBAR, CONTROLS

7.1

Handlebar position

0 0
7.2

Adjusting the handlebar position

Warning
Danger of accidents Handlebar breakage.
–
If the handlebar is bent or straightened it will cause material fatigue, and the handlebar can break. Always replace handle-
bar.
0 0
7.3

Adjusting the basic position of the clutch lever

On the upper triple clamp, there are two holes at a distance of
Hole distance
The holes on the handlebar supports are placed at a distance of
Hole distance
The handlebar supports can be mounted in four different positions.
B01035-10
–
Remove screws
to one side.
Info
Protect the motorcycle and its attachments against damage by covering
them.
Do not bend the cables and lines.
–
Remove screws
–
Move the handlebar supports into the desired position. Mount and tighten
B01036-10
screws .
2
Guideline
Screw, handlebar support
Info
Position the left and right handlebar supports evenly.
–
Position the handlebar.
Info
Make sure cables and wiring are positioned correctly.
–
Position the handlebar clamps. Mount screws
Guideline
Screw, handlebar clamp
Info
Make sure the gap width is even.
–
Adjust the basic position of the clutch lever to your hand size by turning adjusting
screw .
1
Info
When the adjusting screw is turned clockwise, the clutch lever moves away
from the handlebar.
When the adjusting screw is turned counterclockwise, the clutch lever
moves closer to the handlebar.
The range of adjustment is limited.
Turn the adjusting screw by hand only, and do not apply force.
B01710-10
Do not make any adjustments while riding!
15 mm (0.59 in)
A
3.5 mm (0.138 in)
B
. Remove the handlebar clamps. Take off the handlebar and lay it
1
. Take off the handlebar supports.
2
M10
to each other.
A
from the center.
B
Loctite
40 Nm
(29.5 lbf ft)
and tighten evenly.
1
M8 20 Nm
(14.8 lbf ft)
32
® 243™