Table of Contents
Advertisement
AirCheck G2 Wireless Tester
User Manual
L
XII.
OCATING AN
1
To locate an access point: Select Access Points, then use
and
to go to the Access Point Details screen for
L
the access point you want to locate.
To locate a client: From the home screen, select Clients.
Use
to highlight the client you want to locate.
2
Press
Locate. Figure 26 shows the Locate Access
Point screen. Figure 27 shows the Locate Client screen.
3
Divide the area you want to search into four sections, as
shown in Figure 28. Go to one corner of the area.
4
Make a note of the signal strength.
5
Go to the other three corners of the area and make a
note of the signal strength at each corner.
6
Go to the first corner of the section that has the
strongest signal.
7
Do steps 4, 5, and 6 again until you find the access point
or client.
If you do not find the access point or client, look on the
floor above or below you.
A
P
CCESS
OINT OR A
Notes
C
LIENT
If you cannot find a client, and the client shows a
connection to the network, first find the access point that
the client used, then look for the client.
In large, open areas the optional external antenna can help
you locate access points or clients more quickly. See page 59.
A
C
Figure 26. Locate Access Point Screen
Network name (SSID) and access point MAC address
(BSSID).
56
E
F
G
B
D
ffy07.eps
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the AirCheck G2 and is the answer not in the manual?
Questions and answers