Autotest Network Tests - Netscout AirCheck G2 User Manual

AirCheck G2 Wireless Tester
User Manual

AutoTest Network Tests

The Network Test measurements check for network
availability, the existence of interference from access points
using the same channel which may cause network slowness,
AP use of consistent security methods for a network, and the
ability to connect and use the network (access to services,
other devices) and provide network quality.
To set up network security from the home screen, go to the
Networks screen, touch the network you want to examine,
and then, touch the Connect button. See Entering Security
Credentials on page 38 for Connect procedures.
Network Quality tests are run for each SSID in the current
profile. The results are reported on the AutoTest screen. All
discovered SSIDs will be tested against if no SSIDs are set up
in the profile.
The Connection test results indicate whether or not you can
connect at your current location. The health of your
connection, e.g., packet tx rate, packet retries, and if you can
reach other devices on the network, e.g., ping.
The results are presented along with a rating symbol:
Pass, Warning, or Fail.
Figure 12. AutoTest Screen
24