Netscout AirCheck G2 User Manual page 49

Once you enter security credentials for an SSID (or multiple
SSIDs), save them to a profile to avoid losing these settings
when the tester is turned off.
1 From the home screen, select Settings, then select
Manage profiles / network passwords.
2 Select Save profile. The profile name displays at the
bottom of the screen.
3 Either select Save or select

the profile filename.
To load a profile
1 From the home screen, select Settings, then select
Manage profiles / network passwords.
2 Select Load profile, highlight the correct profile, press
, then press Load.
L 
Or
3 Press Profile from the home screen and then Load

profile.
To connect to a network
1 If the network is secure, you must load a configuration
profile that has security credentials for the network. See
page 10.
2 From the home screen, select Networks.
Edit and change

3 Highlight the network in the Networks (SSIDs) list, then
press Connect.

To connect to a specified access point
1 If the access point is secure, you must use a
configuration profile that has security credentials for the
access point. See page 10.
2 From the home screen, select Access Points.
3 Highlight the access point in the Access Points list, then
press Connect.

To do a ping or a TCP Port Connect test
1 Connect to a network or access point, then press
Start tests.
Ping or TCP Port Connect test targets can be added by
selecting Settings > Manage profiles / network
passwords > Edit targets > Add. You can add a target
with an IP address or hostname (URL).
If an * is on the right of Connect, this indicates security
has not been configured on the tester for that network.
Press Connect* and you are guided through entering the
security settings.
41
Verifying Connectivity
Note
