Maintenance; Cleaning The Tester; Updating The Aircheck G2 Firmware - Netscout AirCheck G2 User Manual

M
XVI. AINTENANCE

To prevent possible fire, electrical shock, personal
injury, or damage to the tester:
Do not open the case. You cannot repair or

replace parts in the case.
Use only replacement parts that are approved

by the manufacturer.
If you replace parts that are not specified as

replacement parts, the warranty will not apply
to the product and you can make the product
dangerous to use.
Use only service centers that are approved by

the manufacturer.

Cleaning the Tester

To clean the display, use lens cleaner and a soft, lint-free
cloth. To clean the case, use a soft cloth that is moist with
water or water and a weak soap.

Warning
To prevent damage to the display or the case, do
not use solvents or abrasive materials.

Updating the AirCheck G2 Firmware

1 Download the AirCheck G2 update file from the Fluke
Networks website, or contact Fluke Networks to get the
update by other means. Save the file to your hard disk.
2 Get the latest version of AirCheck G2 Manager from the
Fluke Networks website.
3 Start AirCheck G2 Manager on your PC.
4 Turn on the tester.
5 Use the USB cable supplied with the tester to connect
the tester to the PC.
6 In AirCheck G2 Manager, select AirCheck G2 > Update
Software.
You can also update the vendor MAC prefix file
(oui_abbr.txt) used to resolve vendor MACs in the
AirCheck G2 device list.
69
Caution

Note

Maintenance