To Set The Clock; To Modify Clock (After Previously Set); To Set Date; To Modify Date (After Previously Set) - Tork DTS400B Instruction Manual

DTS400B - DZS400BP 3/9/07
1.0

TO SET THE CLOCK

Press HOUR and MIN to advance to the present
hour and mins. Check AM/PM, and press ENTER.
1.1 TO MODIFY CLOCK
Press MODE until the display shows: CLK. Press
H O U R a n d M I N. to modify clock and press
ENTER.
2.0

TO SET DATE

If you are setting for the first time, display will show:
Press MONTH, DATE, and YEAR key to advance
to the desired Month, date and year, then press
ENTER.
NOTE: The day of the week will be automatically
set once the date is set.
2.1 TO MODIFY DATE
Press MODE until the display shows DATE. Press
MONTH, DATE and YEAR to modify present set-
tings and then press ENTER.
3.0

DAYLIGHT SAVING TIME

After setting or modifying the date, display will
show:
NOTE: If daylight saving time (DST) is NOT
required, press MODE, display will show:
10:15 AM Page 11
4
- Apply AC power to unit
- Insert the pin in the small pinhole (located in
the upper right hand corner) to reset the unit.
- The unit will display the model # and the rev. #,
followed by:
NOTE: Make sure Memory Module with program is
inserted in the unit.
This will prepare the unit to read schedule settings
from the inserted Memory Module. Press EVENT,
display will show:
This will read the schedule settings from the insert-
ed Memory Module. Press ENTER. Display will
show:
This will prepare the schedule settings to be copied
to next Memory Module. Remove inserted Memory
Module and insert Memory Module to be copied.
Press EVENT, display will show:
Press ENTER. Schedule settings will be copied to
the current Memory Module, display will show:
13