To Exit Keypad Programming; Other Keypad Functions; Multiple Keypads - JVA Z14 Installation And User Manual

JVA ELECTRIC FENCE SYSTEMS
The message order is:
● Service Message (Displayed under "System Trouble")
● Dealer Message (Displayed under the standby message: "Ready to Arm")
● Soft Zone Identifiers (A, B, And C) (not used)
● Hardwired Loop Identifiers (Zone 1 = Gate, Zone 3 = Fence)
● Keypad Address (used in Group Mode). If two keypads are used to control one
energizer, one of the keypad addresses MUST have an ID of 2. The other keypad
can have an ID of from 1 to 8 but excluding 2.

9.3 To Exit Keypad Programming

When you have finished programming, press [*] [#].
NOTE: The keypad will also exit the programming mode if you do not press any key
within a five minute period.

9.4 Other Keypad Functions

● To turn the backlight on or off. [*][8][#]
● To turn the audible feedback on or off. [*][5][1][#]
● To change the Keypad Messages to English [*][3][1][#]
● To change the Keypad Messages to Spanish [*][3][2][#] (not well supported yet)
Access the User Menu system by pressing the House key (

9.5 Multiple Keypads

All Z series energizers have support for up to two keypads provided the Energizers
firmware version is 7v66 and above. If more than one keypad is desired one of the
keypads must have an ID of 2, the other keypad can have an ID number from 1 to
8 but excluding ID 2. If only one keypad is desired any ID number from 1 to 8 can
be used.
)
35