Changing The Keypad Messages - JVA Z14 Installation And User Manual

9.2 Changing the Keypad Messages

You can change the messages and each of the 8 zone labels.
● The Dealer Message displays when the system is on standby.
● Zone Labels displays after the [#] key is pressed during alarm memory or faults.
● The programmable Service Message is displayed during AC failure, fuse failure,
communication failure, or low battery.
[1]
[4]
 Cursor left
[7]
[*]
● To activate the keypad programming mode, enter the [Installer's Code] [*] [0]
[1] [#]. Information may be entered into the keypad in the form of letters (upper
and lower case), numbers (0–9), and 22 special symbols. All characters are
displayed in the order: upper and lower case letters, numbers, and special
symbols. The [Space] character precedes the letter A.
● To enter a Label, use the [2] key to scroll through the characters until you reach
the desired character. If you scroll past the desired character, the [8] key may be
used to scroll backwards. NOTE: The space character is before the A character
(When A is displayed, press [8] to get a space).
● When the desired character is displayed, press the [6] key to move the cursor to
the next character position. The [4] key moves the cursor to the left.
● When all characters have been entered, press the [#] key to enter the message
and move to the next message position.
● Use the [0] key to move backward through the messages.
NOTE: If you move to the next message using [5] instead of the [#] key you will
lose any changes you made!
34
JVA ELECTRIC FENCE SYSTEMS
[2] Character up
[5] Next Message
[8] Character down [9]
[0] Last Message
Keys used for changing messages
[3] not used Emergency not used
[6]  Cursor right Fire not used
Panic not used
[#] Enter/Exit Bypass not used