Installation; Installation Steps - JVA Z14 Installation And User Manual

5. INSTALLATION

JVA recommends installation by qualified technicians.

5.1 Installation Steps

1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.
15.
16.
17.
18.
12
JVA ELECTRIC FENCE SYSTEMS
Read the entire manual first!
Design and build the fence. (Beyond the scope of this manual.) Ask your
distributor for help if required.
Decide where the JVA Z14 is to be mounted. If on an external wall it
should be housed within a waterproof equipment box and definitely not
in direct sunlight.
Remove the JVA Z14 PCB chassis from the housing by removing the 2
screws.
Mount the housing by using 4 screws through the rear of the box.
Replace the PCB chassis.
If using a keypad, remove the rear housing of the keypad and fix it to
the wall.
Wire the low voltage cables to the PCB terminals
Wire the high voltage cable to the PCB terminals
If earth monitoring is not going to be used on the fence, connect a
bridge wire from earth out to earth return.
Ensure that the key switch is off.
Fit the battery leads to the battery. The Status Light should blink twice
repetitively to show mains fail, unless J3 is fitted.
Mount the 220 – 16V transformer and connect the 16V side to the Z14
16V input terminals. (AC is not polarity sensitive.) Do not connect a live
or neutral to the earth terminal.
Replace the front cover.
Turn AC power on.
Arm and disarm the energizer via the keyswitch or keypad, if fitted. The
Status Light should stop blinking.
Arm the unit. The LCD display will now show the fence voltage.
Check to ensure that a short anywhere on the fence triggers the alarm.
Ensure that the user understands how to change the user code (PIN)
and is in possession of this Installer/User Manual and the installer's
contact details.
*
NB
Keep high voltage and low voltage cables at least 100mm apart.
Do not run high and low voltage cables in the same conduit.
*
. (See page 13)
*
. (See page 13)