Programming Options In Brief - JVA Z14 Installation And User Manual

See page 23 for more detail.
Option
01
02
03
05
06
07
08
09
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
24
JVA ELECTRIC FENCE SYSTEMS
Function Description
Power Level Sets the output power levels
Low Power level Sets the output power levels used in Low Power mode
Fence Alarm Sets the voltage threshold below which the fence alarm will
Voltage occur
Low Power Sets the voltage threshold below which the fence alarm will
Alarm Level occur in Low Power mode
Missed Pulse Sets the number of pulses which may be missed before the
Count alarm is activated
Battery Alarm Sets the battery voltage threshold below which the general
Voltage alarm will activate
Siren On Time Sets the time that the siren (and keypad beeper) will stay on
after an alarm
Siren Off Time The amount of time the siren will be off for after the On time
has expired
Siren Cycles The number of times the siren will sound for the On
time function above. After this many cycles the siren will
automatically mute
Input Inversion Input normally open or normally closed
Gate Input Gate Switch mode or Low Power Switch mode
Function
Gate Exit Delay Time from gate switch opening to alarm
Chime Mode Allows the keypad and internal beeper function to be altered
Fence Mode Bi-Polar or Conventional mode. Requires hardware change,
which can be done by nearest JZA service centre
Binary Options Miscellaneous options
Anti-bridging If the voltage rises OR falls quickly by more than this setting
as a percentage of the average fence voltage the alarm will
occur
Binary Options 2 Miscellaneous options
Not used
Auto Re-arm Sets the time which must elapse after an alarm has timed
Time out (completed the Siren Cycles) before the Energizer will
automatically re-arm ready for the next alarm event.
Relay 1 Used to assign an alarm function to relay 1
Relay 2 Used to assign an alarm function to relay 2
Relay 3 Used to assign an alarm function to relay 3
Relay 4 Used to assign an alarm function to relay 4
Relay 5 Used to assign an alarm function to relay 5
Group Mode Allows the energizer to be set as a Master or slave in a
synchronized group. Not available in all markets.
Programming Options