Auto Re-Arm Time (20X#); Relay Functions - JVA Z14 Installation And User Manual

JVA ELECTRIC FENCE SYSTEMS

8.6.18 Auto Re-arm Time (20x#)

This option sets the time which must
elapse before another alarm will sound
after the first alarm has timed out (gone
completely through its cycles without
being turned off).
If an event occurs (such as a low fence
voltage) which triggers the siren, any
other events which would otherwise
trigger the siren (such as a gate alarm)
will be ignored while the siren is sounding
and until after the Auto Re-arm time has
passed.
A setting of 9 will disable Auto Re-arm.

8.6.19 Relay Functions

All relays can be set to any of the
available functions (user assignable).
Relay 1 is (21x#)
Relay 2 is (22x#), etc.
Even though the three additional relays
are not fitted to the Z14, Relays 3, 4 and
5 can still be programmed. The modes
are explained in the table opposite.
The defaults for the Z14 are:
• Relay 1 – Siren
• Relay 2 – Strobe
• Relay 3 – Fence (Note: Relay 3 is not
physically fitted to PCB)
• Relay 4 – Armed 1 (Note: Relay 4 is
not physically fitted to PCB)
• Relay 5 – General (Note: Relay 5 is
not physically fitted to PCB)
NOTE: Optional extra relays can be
retro-fitted. Contact your nearest JVA
service centre for details.
Value
0 0 Seconds (Immediate)
1 30 Seconds
2 1 Minute
3 2 Minutes
4 3 Minutes
5 4 Minutes
6 5 Minutes
7 6 Minutes
8 7 Minutes
9 Disabled – do not auto-rearm
Auto Re-arm Time Values (20x#)
Value
0 Fence 1
1 Fence 1 or off
2 Armed 1
3 Fence 2
4 Fence 2 or off
5 Armed 2
6 Fence Bi-Polar
7 General
8 Siren
9 Strobe
10 AC Fail
11 Low/Bad Battery
12 Tamper
13 Strobe 2
14 Gate 1 or 2
15 Siren caused by Gate 1 or 2
16 Armed in Low Power Mode
17 Group Armed Note 3
18 Group General
Relay Functions Values
Time
Time
31