3D Disto, Instrument Setup
5.4.4
Data import
Data Transfer
Other USB memory sticks may be used, but Leica Geosystems recommends Leica
industrial grade USB memory sticks and cannot be held responsible for data loss or
any other error that may occur when using a non-Leica USB memory stick.
It is possible to import DXF files or table formats for some applications. Data should
be prepared on the PC before importing. Only points are imported, no lines. The data
source can be a PC or a USB stick plugged into the Control Unit.
Remove irrelevant data such as frames, logos, coordinates, or orientation
arrows in the DXF files before importing them.
USB Cable
1. For import from PC, connect powered
Control Unit and PC by Micro-USB
cable.
3D Disto_011
74