Leica 3D Disto User Manual page 118

3D Disto, Software Applications
1. Press Menu » Applications » Location » Relocation.
2. A pop-up prompts you to define the tolerance.
Press OK to confirm the value.
A lower tolerance increases the accuracy of
your measurements and requires precise
aiming and visibility of the Secure Points.
3. If there are no Secure Points in the memory, pop-up prompts Not enough
Secure Points in the memory.
If there are no Secure Points available but your measurement must fit
to the geometry of a previous one, just start your measurement with
the same Base Line points. These are the first two points of a meas-
urement.
118