Leica 3D Disto User Manual page 142

3D Disto, Software Applications
5. If you select enter, pop-up prompts to enter grid points spacing.
6. The grid geometry is displayed in a pop-up.
7. If grid is ok, choose yes and layout mode starts.
If grid is not ok, proceed as described in 2. to 7.
8. In layout mode the
Toolbar changes and
you can start to project
the grid. Use the arrow
keys to select a point
and press .
Porous, structured or rough surfaces cause problems if the laser beam
cannot reflect off the exact position of the layout point.
You can also select points by tapping on a point on the screen or by using
the Remote Control.
9. Laser point flashes if the exact position is found. Point is highlighted in red in
sketch area.
142