Specifying The Sip Subslot Location For A Spa - Cisco ASR 1000 Configuration Manual

Configuration Tasks
•
•
•
•
Some commands such as show platform, show diag, and show diag subslot allow you to display
information about the SIP. However, you must specify the chassis slot location where the SIP about
which you want information is installed.

Specifying the SIP Subslot Location for a SPA

SIP subslots begin their numbering with "0" and have a horizontal orientation, as shown in
The Cisco ASR 1000 Series SIP supports four subslots for the installation of SPAs. The subslot locations
are oriented as follows:
•
•
•
•
In the Cisco ASR 1002 Router, SIP subslot 0 is not available for SPA insertion. It is the slot that is used
Note
for the integrated Route Processor and Gigabit Ethernet ports.
The slots 4 and 5 on Cisco ASR 1013 Series Router has limitation to support ASR-SIP40 at 40G mode.
Warning
Figure 4-1
Figure 4-1
The SIP subslot numbering is indicated by a small numeric label beside the subslot on the faceplate.
Just as with the SIPs, some commands allow you to display information about the SPA itself, such as
show diag subslot. These commands require you to specify both the physical location of the SIP and
SPA in the format, slot/subslot, where:
•
•
To display the operational status for a SPA installed in the SIP, enter the show platform command.
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide
2
The Cisco ASR 1006 Router supports three chassis slots for SIPs.
The Cisco ASR 1004 Router supports two chassis slots for SIPs.
The Cisco ASR 1002 Router supports one chassis slot for a SIP that is permanently installed, and
the integrated Route Processor and Gigabit Ethernet ports reside in SPA subslot 0.
The Cisco ASR 1013 Router supports six chassis slot for SIPs.
SIP subslot 0—Top-left subslot
SIP subslot 1—Top-right subslot
SIP subslot 2—Bottom-left subslot
SIP subslot 3—Bottom-right subslot
shows the SPA numbering sequence on a Cisco ASR 1000 Series Routers SIP.
Cisco ASR 1000 Series SIP SPA Numbering
Front of SIP, horizontal chassis slots
SPA 0 SPA 1
SPA 2 SPA 3
slot—Specifies the chassis slot number in the Cisco ASR 1000 Series Aggregation Services Routers
where the SIP is installed.
subslot—Specifies the slot of the SIP where the SPA is installed.
Configuring the SIP
Figure 4-1.
OL-14127-08