Interface Configuration Mode - Cisco ASR 1000 Configuration Manual

Configuration Tasks
Command
Router# configure terminal
Router(config)# controller t3 slot/subslot/port
Router(config-controller)# t1 number fdl {ansi}
Verifying FDL
Use the show controller command to display the FDL setting:
Router# show controller t3 3/0/1/1
T3 3/0/1 is down.
ATLAS FPGA version: 0, FREEDM336 version: 0
TEMUX84(1) version: 0, TEMUX84(1) version: 0
SUBRATE FPGA version: 0
Applique type is Channelized T3
Receiver has loss of signal.
Framing is M23, Line Code is B3ZS, Clock Source is Internal
Equipment customer loopback
Data in current interval (456 seconds elapsed):
T1 1 is down
timeslots: 2-14
FDL per ANSI T1.403 and AT&T 54016 spec.
Configured for FDL remotely line looped (bell)
Transmitter is sending LOF Indication.
Receiver is getting AIS.
Framing is ESF, Clock Source is Line
BERT running on timeslots 2,3,4,5,6,7,8,9,10,11,12,13,14,
BERT test result (running)
Data in current interval (703 seconds elapsed):
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide
16-14
Hardware is 2 ports CT3 SPA
0 Line Code Violations, 0 P-bit Coding Violation
0 C-bit Coding Violation, 0 P-bit Err Secs
0 P-bit Severely Err Secs, 0 Severely Err Framing Secs
456 Unavailable Secs, 0 Line Errored Secs
0 C-bit Errored Secs, 0 C-bit Severely Errored Secs
0 Severely Errored Line Secs
0 Far-End Errored Secs, 0 Far-End Severely Errored Secs
0 CP-bit Far-end Unavailable Secs
0 Near-end path failures, 0 Far-end path failures
0 Far-end code violations, 0 FERF Defect Secs
0 AIS Defect Secs, 456 LOS Defect Secs
Test Pattern : All 1's, Status : Not Sync, Sync Detected : 0
Interval : 2 minute(s), Time Remain : 2 minute(s)
Bit Errors (since BERT started): 0 bits,
Bits Received (since BERT started): 0 Kbits
Bit Errors (since last sync): 0 bits
Bits Received (since last sync): 0 Kbits
0 Line Code Violations, 0 Path Code Violations
0 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins
Chapter 16 Configuring the 2-Port and 4-Port Channelized T3 SPAs
Purpose
Enters global configuration mode.
Selects the controller to configure and enters

interface configuration mode.

slot/subslot/port—Specifies the location of the
•
controller. See also the
Interface Address on a SPA" section on
page 16-7.
(Optional) Enables FDL.
number—Specifies the T1 channel number.
•
ansi—Specifies the FDL bit per the ANSI
•
T1.403 specification.
"Specifying the
OL-14127-08