Configuration Tasks - Cisco ASR 1000 Configuration Manual

Configuring the ATM SPAs
This chapter provides information about configuring the ATM SPAs on the Cisco ASR 1000 Series
Aggregation Services Routers. It includes the following sections:
•
•
•
For information about managing your system images and configuration files, refer to the following
publications:
•
•
For information about configuration of other features supported in the Cisco IOS XE software on the
Cisco ASR 1000 Series Routers, and the commands used in this chapter, see the
Documentation" section on page

Configuration Tasks

This section describes the most common configurations for the ATM SPAs on Cisco ASR 1000 Series
Router. It contains procedures for the following configurations:
•
•
•
•
•
•
•
•
•
•
•
OL-14127-08
Configuration Tasks, page 7-1
Verifying the Interface Configuration, page 7-27
Configuration Examples, page 7-28
Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide
Cisco IOS XE Configuration Fundamentals Configuration
Required Configuration Tasks, page 7-2
Specifying the Interface Address on a SPA, page 7-4
Modifying the Interface MTU Size, page 7-4
Creating a Permanent Virtual Circuit, page 7-9
Creating a PVC on a Point-to-Point Subinterface, page 7-11
Configuring a PVC on a Multipoint Subinterface, page 7-13
Configuring a Range of PVCs on a Multipoint Subinterface, page 7-15
Configuring Traffic Parameters for PVCs, page 7-17
Configuring Virtual Circuit Classes, page 7-20
Configuring SONET and SDH Framing, page 7-21
Configuring AToM VP Cell Mode Relay Support, page 7-23
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide
C H A P T E R
xxvi.
7
Guide, Release 2.
"Related
7-1