Configuration Examples - Cisco ASR 1000 Configuration Manual

Configuration Examples

LOP = 0
Active Defects: None
Active Alarms:
Alarm reporting enabled for: SF SLOS SLOF B1-TCA B2-TCA PLOP B3-TCA
Framing: SONET
APS
COAPS = 0
State: PSBF_state = False
Rx(K1/K2): 00/00
Rx Synchronization Status S1 = 00
S1S0 = 00, C2 = 00
Remote aps status (none); Reflected local aps status (none)
--More--
RDOOL = 0
State: RDOOL_state = False
PATH TRACE BUFFER: UNSTABLE
Remote hostname :
Remote interface:
Remote IP addr
Remote Rx(K1/K2):
BER thresholds:
TCA thresholds:
Clock source:
Configuration Examples
This section includes the following examples for configuring a POS SPA installed in a Cisco ASR 1000
Series Router:
•
•
•
•
•
•
•
•
•
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide
13-12
NEWPTR = 0
None
PSBF = 0
Tx(K1/K2): 00/00
:
/
SF = 10e-3
B1 = 10e-6
line
Basic Interface Configuration Example, page 13-13
MTU Configuration Example, page 13-13
POS Framing Configuration Example, page 13-14
Keepalive Configuration Example, page 13-14
CRC Configuration Example, page 13-14
Clock Source Configuration Example, page 13-15
SONET Payload Scrambling Configuration Example, page 13-15
Encapsulation Configuration Example, page 13-15
POS Alarm Trigger Delays Configuration Example, page 13-16
PSE = 0
CLOCK RECOVERY
Tx(K1/K2): /
SD = 10e-6
B2 = 10e-6 B3 = 10e-6
Chapter 13 Configuring the POS SPAs
NSE = 0
OL-14127-08