Verifying Interface Configuration - Cisco ASR 1000 Configuration Manual

Configuration Tasks
Total Data (last 1 15 minute intervals):
T1 1 is down
timeslots: 1-24
FDL per AT&T 54016 spec.
Transmitter is sending LOF Indication.
Receiver is getting AIS.
Framing is ESF, Clock Source is Internal
Data in current interval (734 seconds elapsed):
Data in Interval 1:
Total Data (last 1 15 minute intervals):
T1 2

Verifying Interface Configuration

Use the show interface serial command to verify the interface configuration. The following example
shows the output for the serial interface for an unchannelized T3:
Router# show interface serial3/0/0
Serial3/0/0 is down, line protocol is down
Hardware is SPA-4XCT3/DS0
MTU 4470 bytes, BW 44210 Kbit, DLY 200 usec,
Encapsulation HDLC, crc 16, loopback not set
Keepalive set (10 sec)
Last input never, output never, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide
16-6
0 AIS Defect Secs, 0 LOS Defect Secs
2 Line Code Violations, 6 P-bit Coding Violation,
0 C-bit Coding Violation, 1 P-bit Err Secs,
1 P-bit Severely Err Secs, 1 Severely Err Framing Secs,
0 Unavailable Secs, 1 Line Errored Secs,
1 C-bit Errored Secs, 1 C-bit Severely Errored Secs
0 Severely Errored Line Secs
0 Far-End Errored Secs, 0 Far-End Severely Errored Secs
10 CP-bit Far-end Unavailable Secs
0 Near-end path failures, 1 Far-end path failures
0 Far-end code violations, 10 FERF Defect Secs
0 AIS Defect Secs, 0 LOS Defect Secs
0 Line Code Violations, 0 Path Code Violations
0 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins
0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs
733 Unavail Secs, 0 Stuffed Secs
367 Near-end path failures, 0 Far-end path failures, 0 SEF/AIS Secs
0 Line Code Violations, 0 Path Code Violations
0 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins
0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs
706 Unavail Secs, 0 Stuffed Secs
353 Near-end path failures, 0 Far-end path failures, 0 SEF/AIS Secs
0 Line Code Violations,0 Path Code Violations,
0 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins,
0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs
706 Unavail Secs, 0 Stuffed Secs
353 Near-end path failures, 0 Far-end path failures, 0 SEF/AIS Secs
Not configured.
reliability 255/255, txload 1/255, rxload 1/255
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts (0 IP multicast)
0 runts, 0 giants, 0 throttles
Chapter 16 Configuring the 2-Port and 4-Port Channelized T3 SPAs
OL-14127-08