Classification And Scheduling Restrictions; Information About Ingress Classification; Ingress Classification Architecture - Cisco ASR 1000 Configuration Manual

Aggregation services routers sip and spa software
Hide thumbs Also See for ASR 1000:
Table of Contents

Advertisement

Chapter 27
Classifying and Scheduling Packets for ASR 1000 Series
The above listed new commands for ingress classification and scheduling are documented in the Cisco
Note
IOS Quality of Service Solutions Command Reference guide at the URL
http://www.cisco.com/en/US/docs/ios/qos/command/reference/qos_book.html.

Classification and Scheduling Restrictions

Following are the restrictions pertaining to the classification feature:
Following are the restrictions pertaining to the scheduling feature:

Information About Ingress Classification

The following sections provide details of the Ingress classification feature:

Ingress Classification Architecture

The Cisco ASR 1000 Series Routers support ingress oversubscription. However, in case of
oversubscription, it is important that the processing of the high-priority packets such as Internet control,
L2 keepalives, signaling protocols, and high-priority data packets is done by the SIP or SPA over the
low-priority packets.
oversubcription.
OL-14127-08
The maximum number of ingress class map templates configured per CC is 62 templates.
Classification support is not enabled for logical interfaces such as multilink and tunnel interfaces.
Packet classification CLI is disabled for mulitlink member links.
Classification CLI cannot be enabled for frame relay subinterfaces.
Classification is not supported for service SPAs such as WebEx.
For clear-channel SPAs such as Ethernet, Serial, POS, and ATM SPAs, excess bandwidth settings
are configured at the physical interface level. For channelized SPAs, the excess bandwidth settings
can be set at the SPA level.
Configurations built using high capacity CC or ESP, will be restored with best effort when a
low-capacity CC or ESP replaces the high-capacity CC or ESP. Also, any per-CC minimum
bandwidth configuration exceeding its ESI link capacity will be replaced with the corresponding ESI
link's maximum capacity.
When configuring the minimum CC bandwidth, the available range is 0 to the minimum carrier-card
bandwidth and ESP bandwidth.
Ingress Classification Architecture, page 27-3
Resolving Oversubscription, page 27-5
Ingress Classification Overview, page 27-5
Table 27-3
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide
illustrates the various SPA, SIP, and ESP combinations that cause
Classification and Scheduling Restrictions
27-3

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents