Reactivating A Spa - Cisco ASR 1000 Configuration Manual

Troubleshooting the SIP
Command
Router(config)# hw-module subslot
slot-number/subslot-number shutdown [powered |
unpowered]
Router(config)# hw-module subslot
slot-number/subslot-number {reload | stop | start}
For more information about chassis slot and SIP subslot numbering, refer to the
Subslots for the SIP and SPAs" section on page

Reactivating a SPA

You do not need to reactivate a SPA after an OIR of either the SIP or a SPA if you did not deactivate the
Note
SPA prior to removal when using the hw-module subslot command in global configuration mode. If the
Cisco Aggregation Services Router-1 is running, then the SPAs automatically start upon insertion into
the SIP or with insertion of a SIP into the Cisco Aggregation Services Router-1.
If you deactivate a SPA using the hw-module subslot stop command, and need to reactivate it without
performing an OIR, you must use the hw-module subslot start command to reactivate the SPA and its
interfaces.
To activate a SPA and its interfaces after the SPA has been deactivated, use the following command in
global configuration mode:
OL-14127-08
Purpose
Deactivates the SPA in the specified slot and subslot of the SIP,
where:
slot-number—Specifies the chassis slot number where the SIP
•
is installed.
subslot-number—Specifies the subslot number on a SIP where
•
a SPA is installed.
• powered—(Optional) Shuts down the SPA and all of its
interfaces, and leaves them in an administratively down state
with power enabled. This is the default state.
unpowered—(Optional) Shuts down the SPA and all of its
•
interfaces, and leaves them in an administratively down state
without power.
Deactivates the SPA in the specified slot and subslot of the SIP,
where:
slot-number—Specifies the chassis slot number where the SIP
•
is installed.
subslot-number—Specifies the subslot number on a SIP where
•
a SPA is installed.
reload—Stops and restarts the specified SPA.
•
stop—Stops the specified SPA.
•
start—Starts the specified SPA.
•
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide
Preparing for Online Insertion and Removal of the SIP and SPAs
4-1.
"Identifying Slots and
7