Cisco ASR 1000 Configuration Manual page 112

Aggregation services routers sip and spa software
Hide thumbs Also See for ASR 1000:
Table of Contents

Advertisement

Configuration Tasks
Command or Action
Step 1
Router(config)# interface atm slot/subslot/port
Step 2
Router(config-if)# shutdown
Step 3
Router(config-if)# end
When you shut down an interface, the show interface command indicates that the interface is
Tip
administratively down until the SPA is physically removed from the chassis or until the SPA is
re-enabled.
The following shows a typical example of shutting down an ATM SPA interface:
Router> enable
Router# configure terminal
Router(config)# interface atm 0/2/2
Router(config-if)# shutdown
Router(config-if)# end
Router# show interface atm 0/2/2
ATM0/2/2 is administratively down, line protocol is down
Hardware is SPA-3XOC3-ATM, address is 000d.2959.d5ca (bia 000d.2959.d5ca)
Internet address is 10.10.10.16/24
MTU 4470 bytes, sub MTU 4470, BW 599040 Kbit, DLY 80 usec,
Encapsulation ATM, loopback not set
Encapsulation(s): AAL0
4095 maximum active VCs, 1 current VCCs
VC idle disconnect time: 300 seconds
0 carrier transitions
Last input 01:01:16, output 01:01:16, output hang never
Last clearing of "show interface" counters 01:10:21
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/0 (size/max)
30 second input rate 0 bits/sec, 0 packets/sec
30 second output rate 702176000 bits/sec, 1415679 packets/sec
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide
7-26
reliability 255/255, txload 42/255, rxload 1/255
1000 packets input, 112000 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
2948203354 packets output, 182788653886 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 output buffer failures, 0 output buffers swapped out
Purpose
Enters interface configuration mode for the indicated port
on the specified ATM SPA.
Shuts down the interface.
Exits interface configuration mode and returns to privileged
EXEC mode.
Chapter 7
Configuring the ATM SPAs
OL-14127-08

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents