Remote I/O Station Parameter Settings; Remote I/O Station Possible Parameter Settings - Mitsubishi Electric QJ71LP21 Reference Manual

5 PARAMETER SETTINGS

5.2 Remote I/O Station Parameter Settings

5.2.1 Remote I/O station possible parameter settings

Major item
Number of empty slots
PLC system settings
Module synchronization
Operation mode upon an error
PLC RAS settings
Error check
Remote I/O switch settings
Assignment method
Operational settings
Forwarding parameter between devices
I/O assignment
I/O assignment
Standard setting
5 - 26
For remote I/O stations, set up the PLC parameters, network parameters, and remote
password on the remote I/O module as needed.
POINT
After writing the parameters to the remote I/O module, reset it to enable the
parameters that have been set. To reset the remote I/O module, use the reset
switch on the body of the main module or reset the power supply for the remote I/O
station.
The following parameters are set as needed on the remote I/O station and written to
the remote I/O module.
If settings are not needed, the remote I/O station operates using the remote I/O module
default settings so there is no need to write the parameters to the remote I/O module.
(1) PLC parameters
The remote I/O module can set the set the PLC parameters in the same manner
as the CPU module. However, only the required items can be set as a remote
I/O station.
Intermediate item Small item
Number of empty slots
Synchronizes intelligent module's pulse
up
Fuse blown
1
I/O module verification error
Carry out fuse blown check
Carry out I/O module comparison
Remote I/O switch settings
Points/start
Start/End
Device name
Points/Start
Start/End
Type
Model name
Points
Start
Base model name
Power model name
Extension cable
Points
Base mode
MELSEC-Q
Default value
16 points
Synchronizes
Stop
Stop
Checks
Checks
—
Start/End
No setting
No setting
No setting
5 - 26